Tutorials

Instructions for installing Enilor Skins

THE KIT CONTAINS SKIN ENILOR + FILM LAYER + WIPES TO CLEAN THE DEVICE
1) Remove all dirt and dust using the wipes provided.
2) Identify the holes and cutouts in the film and align them precisely with your device.
3) Before removing the film, place it face down on a flat surface, then remove the backing paper from the back and use one side of the skin to help you align it on the device.
4) Check that the edges and cutouts are well aligned on all sides, take all the time necessary for perfect alignment before pressing the film to make it adhere to the device. If you have made any mistakes, don't worry, peel it off carefully and reposition the film correctly.
5) Once you are satisfied with the positioning you can finally spread the film from the bottom with the special film spreader provided, do not press the corners yet.
6) For better adhesion of the product it is advisable to use the hairdryer on the lowest setting and heat the corner of the sheet to make it softer and more flexible. Starting from the inside, gently press the corner with your thumb to make sure the film is positioned correctly. Follow these steps for all corners and curved areas. Before completing the installation, check the correct adhesion of the support, edges and corners and, if necessary, readjust.